Regenerative Turbine Pump Application
Regenerative Turbine Pump able to offer high pressure in relation to comparatively low powers and which have particularly steady operating curves.
They are qualified in domestic fittings, to increase the system pressure in aqueducts and for automatic water distribution by small autoclave tanks or by hydrosphere units.
 For the correct function of Regenerative Turbine Pump, use clean water or non-aggressive liquid only, without sand or other solid impurity.
 
Operating conditions
*Liquid temperature up to 60
*Ambient temperature up to 40
*Total suction lift up to 9mt.
*Continuous duty
 
Motor
*Two-pole induction motor(n=2850r.p.m)
*Insulation Class B
*Protection IP44
 
Material
*Pump body: Cast iron
*Motor support: Cast iron
*Motor housing: Aluminum
*Impeller: Brass
*Shaft with rotor: 45# Steel,AISI 416 stainless steel if request
*Mechanical seal: Carbon/Ceramic
Single phase 220V-240V/50Hz
Single phase 110V-127V/60Hz if request
Single/three phase 220V/60Hz if request